Alpine X009-FD1 Manual de instalación descargar pdf (Pagina 9)

Ford F-150

FULL SIZE TRUCK  9/12

Installation Instructions

1 Attach the Maestro module to the X009 main

harness.

2 Using an air Reciprocating Saw trim the marked

gray area above the headunit. (This will allow the

headunit to sit at the adequate height)

3 Connect the factory harness to the main harness

and secure it.

Only use if vehicle is equipped with a factory

subwoofer and harness was plugged into the OEM

headunit.

4 Remove rubber screw cover from the center dash

plate and extract 2 x 7 mm screws. Place GPS

antenna as illustrated and feed the cable down to

the X009. This is where Sync module and the SW2

wire are located. Can bus wires can also be found

at the Sync module. (see step 5 for color code)

Access the ODBII connector located under the driver

side dashboard. Connect the YELLOW/BROWN wire

from the Alpine harness to the WHITE wire located

at pin 14 of the OBDII connector. Connect the RED/

BROWN wire from the Alpine harness to the WHITE/

BLUE wire located at pin 6 of the OBDII connector.

Connect the PINK/RED wire to the BLUE/ORANGE

wire at the SYNC harness on the top center dash

under the tray. NOTE: On 2011 thru 2014 models,

connection of PINK/RED wire is not required.

PINK/RED -

SWI 2 (-) INPUT

STEERING

WHEEL SIDE

INSULATE

WIRE

SYNC HARNESS

FACTORY RADIO HARNESS

SYNC

MODULE SIDE

WIRES FROM

VEHICLE

YELLOW/BROWN -CAN2L

RED/BROWN - CAN2H

WHITE/BLUE

WHITE

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Alpine X009-FD1 Manual de instalación Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Los sistemas de navegación para automóviles Alpine X009-FD1