Alpine CDE-148EBT Instrucciones de operaciones descargar pdf (Pagina 46)

48-EN

 Microphone (Included) (CDE-148EBT only)

 Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power antenna, if

applicable.

Note

• This lead should be used only for controlling the vehicle’s power

antenna. Do not use this lead to turn on an amplifier or a signal

processor, etc.

 Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your amplifier or

signal processor.

 Illumination Lead (Orange)

This lead may be connected to the vehicle’s instrument cluster

illumination lead. This will allow the backlighting of this unit to dim

whenever the vehicle’s lights are turned on.

 Switched Power Lead (Ignition) (Red)

Connect this lead to an open terminal on the vehicle’s fuse box or

another unused power source which provides (+) 12V only when the

ignition is turned on or in the accessory position.

 Battery Lead (Yellow)

Connect this lead to the positive (+) post of the vehicle’s battery.

 Ground Lead (Black)

Connect this lead to a good chassis ground on the vehicle. Make sure

the connection is made to bare metal and is securely fastened using

the sheet metal screw provided.

 Right Front (+) Speaker Output Lead (Grey)

 Right Front (−) Speaker Output Lead (Grey/Black)

 Right Rear (−) Speaker Output Lead (Violet/Black)

 Right Rear (+) Speaker Output Lead (Violet)

 Left Rear (+) Speaker Output Lead (Green)

 Left Rear (−) Speaker Output Lead (Green/Black)

 Left Front (−) Speaker Output Lead (White/Black)

 Left Front (+) Speaker Output Lead (White)

 USB Connector

Connect this to an USB Memory or to an iPod/iPhone. To use an iPod/

iPhone, Interface cable for iPod connection is required.

Notes

• Use the supplied USB cable. If a USB cable other than the supplied is

used, correct performance cannot be guaranteed.

• Route the USB cable away from other cables.

 Antenna Receptacle

 Rear Output Input RCA Connectors

It can be used as Rear Output or Input RCA connectors.

RED is right and WHITE is left.

 Front Output Input RCA Connectors

It can be used as Front Output or Input RCA connectors.

RED is right and WHITE is left.

 Subwoofer Output RCA Connectors

RED is right and WHITE is left.

 MIC Input Connector

To Microphone.

 Steering Remote Control Interface Connector

To steering remote control interface box.

For details, contact your Alpine dealer.

 Fuse Holder (10A)

 Power Supply Connector

 RCA Extension Cable (sold separately)

 Rear Aux Input Connector (Black)

This connector allows for input of audio from an external device

(such as a portable player), using a commercially-available converter

cable.

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm away from the

car harness.

• Keep the battery power leads as far away from other leads as

possible.

• Connect the ground lead securely to a bare metal spot (remove

any paint, dirt or grease if necessary) of the car chassis.

• If you add an optional noise suppressor, connect it as far away

from the unit as possible. Your Alpine dealer carries various

noise suppressors, contact them for further information.

• Your Alpine dealer knows best about noise prevention

measures so consult your dealer for further information.

00ALPINE.book Page 48 Friday, January 11, 2013 10:01 AM

1 2 ... 41 42 43 44 45 46 47

Comentarios a estos manuales

Sin comentarios

Alpine CDE-148EBT Instrucciones de operaciones Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Receptores de medios de coches Alpine CDE-148EBT